Category Index
This Installation Guide provides the following illustrations: 66 Block, Dual Male Amphenol, wiring and silk screen for 32C8V8R
This cable adapter will allow for Rev D SiteBoss and TeleBoss hardware with round Mini DIN sensor port to communicate with the current version EventSensors that use a RJ45 connection to the host unit.
The 4ES expansion card can be added to any open expansion slot that will increase the number of EventSensor
This Installation Guide features a 32ft cable assembly which is available for use with the 16C card.
Input contact splitters allow each contact input is split into 2 contact outputs thus retaining the capability and function of the existing legacy system.
This guide provides information needed to properly connect and configure a ES-32C8V8R high density expansion card and cable for use.
EventSensor IO is used to add additional I/O points to a base SiteBoss unit either to more perfectly match the number of I/O points needed, or to give future scalability to add more I/O points should they become needed.
This document provides specifications and installation instructions for an ES-Surge.
This document describes how the temperature sensor measures temperature ranges inside a cabinet or equipment room.
This document describes the temperature/humidity sensor which measures both temperature and relative humidity level in one compact device.
This manual provides basic installation and operation details the specified EventSensor products. For special features, use case examples, or application stories, see Manual Addenda or the KnowledgeBase.
This document explains how the ES-6INJ EventSensor Power Injector can be used to add power to extend the length of any ES Sensor chain.
This article describes the use and configuration of the EventSensor Reporting feature which allows one SiteBoss to report EventSensor data to a host SiteBoss.
This document describes the correct procedures for field installation of Expansion Cards in Asentria
Asentria Base units have a wide variety of Expansion cards that can be added to our two and six expansion card base units. This makes are units do exactly what a customer needs and reduces cost, since you do not have to buy what you don't need.
This document explains how High Density EventSensors add the ability to connect to units using a standard EventSensor connection. These add 32 contact closure points, 8 voltage sensors and 8 form C relay points to a SiteBoss site.
This guide provides information needed to properly connect and configure a high density expansion card and cable and punch down pinouts.
This ultra-compact expansion card manages up to 64 inputs/outputs in a single card slot.
This guide describes how to configure No-Data, Scheduled, % full, and other Misc.alarms found in the TeleBoss and Siteboss products.
This article describes the Installation and usage instructions for the 5001- 044, 5001- 045, 5001- 046 and 5000- 004 Water Sensors
