Category Index
Custom 512 wire wrap blocks provide two rows of 32 wire wrap pairs for inputs and grounds, with individual labeling identifying each input post.
Custom 512 wire wrap blocks provide two rows of 32 wire wrap pairs for inputs and grounds, with individual labeling identifying each input post.
This Installation Guide provides the following illustrations: 66 Block, Dual Male Amphenol, wiring and silk screen for 32C8V8R
The 4ES expansion card can be added to any open expansion slot that will increase the number of EventSensor
This is a spec sheet example for a Door Sensor
Spec Sheet for the Overhead door sensor
This Installation Guide features a 32ft cable assembly which is available for use with the 16C card.
Calibrating an Analog Input is normally done at Asentria before the unit or slot card ships. But if a card is in need of calibrating in the field these steps can be taken to get the card back in tolerance.
This guide provides information needed to properly connect and configure a ES-32C8V8R high density expansion card and cable for use.
EventSensor IO is used to add additional I/O points to a base SiteBoss unit either to more perfectly match the number of I/O points needed, or to give future scalability to add more I/O points should they become needed.
This guide provides information needed to properly mount and connect an ESJ-HUB SensorJack Expansion Hub for use with SiteBoss or TeleBoss products.
This manual provides basic installation and operation details the specified EventSensor products. For special features, use case examples, or application stories, see Manual Addenda or the KnowledgeBase.
This article explains the EventSensor MIB OIDs
This Feature Guide gives the equation to determine if your EventSensor string needs additional power to function as well as power supply options.
This article describes the use and configuration of the EventSensor Reporting feature which allows one SiteBoss to report EventSensor data to a host SiteBoss.
This document describes the correct procedures for field installation of Expansion Cards in Asentria
Asentria Base units have a wide variety of Expansion cards that can be added to our two and six expansion card base units. This makes are units do exactly what a customer needs and reduces cost, since you do not have to buy what you don't need.
This Feature Guide explains how to use Global Event actions to apply an action to all enabled Sensors.
This document explains how High Density EventSensors add the ability to connect to units using a standard EventSensor connection. These add 32 contact closure points, 8 voltage sensors and 8 form C relay points to a SiteBoss site.
This guide provides information needed to properly connect and configure a high density expansion card and cable and punch down pinouts.
This ultra-compact expansion card manages up to 64 inputs/outputs in a single card slot.
This guide describes how to configure No-Data, Scheduled, % full, and other Misc.alarms found in the TeleBoss and Siteboss products.
This User guide provides basic specifications, installation instructions and configuration information.
Spec and installation instructions for the DC n Smoke and Heat Detector
This where I get to practice working with Wiki Formating
This is a demonstration of how to setup and use contact closure inputs on a SiteBoss 550
The Water Sensor Adapter was needed for early hardware versions. This is installation and configuration instructions if the adapter is needed.
This article describes the Installation and usage instructions for the 5001- 044, 5001- 045, 5001- 046 and 5000- 004 Water Sensors
This article provides instructions for physical installation and access configurations when using a Wiegand access card reader and the Asentria Wiegand Card Reader SiteBoss Interface
