Category Index
This data sheet applies to the DC Current Transducer (5000-031, 024, 022, 026, 032, 033): 20 mm window, +- 5VDC output, +- 15 VDC power
This data sheet pertains to the Carlo Gavazzi Power Meter.
This Feature Guide discusses the installation and software configuration of the AC Power Monitoring peripheral devices available for use in conjunction with a SiteBoss product.
The DC Current Transducer is used to monitor DC current flow. This document gives installation and configuration instructions.
This document describes the installation and configuration instructions for the Resistive Fuel Sensor Adapter
This article describes how to configure the Fuel Sensor Monitoring feature in the SiteBoss using float, pressure, or ultrasonic fuel sensors.
This document provides instructions for physical installation and access configurations when using an Asentria-provided Gas Pressure Switch.
Instructions for wiring and configuring a generator and ATS to a SiteBoss unit to transfer exercise control to the SiteBoss.
This is a list of equipment that has already had the work done to set up monitoring and/or control using SiteBoss controllers.
This article describes the Load Shedding feature which allows individual configuration of switch and/or relay outputs to selectively shut off power to connected equipment after mains power is lost.
The Power Boss DC60 adds high-current switching capability to any Asentria Base Unit with an EventSensor port.
This document describes the use and configuration of the The Power Boss DC90 which adds high-current switching capability to any Asentria Base Unit with an EventSensor.
The PowerTek intelligent AC power strips are designed to measure the input and individual outlet current consumption and at the same time, provide the ability to managing power for equipment connected to it. User can control the power on/off for any device connected to the PDU remotely.
This article describes the use and configuration of the EventSensor Reporting feature which allows one SiteBoss to report EventSensor data to a host SiteBoss.
This is the User Manual, Installation and Operation Guidelines for the PowerBoss 4.
This document contains a User Manual with Installation and Operation Guidelines for the PowerBoss 6 and PowerBoss 7.
This User Manual describes the Installation and Operation Guidelines for the PowerBoss High Current DC Power Switch.
This document describes the use and configuration of the Slimline Relay which provides a simple means of verifying whether AC voltage is present or a switch (AC or DC power) is on or off.
The Rochester Removable Dial Fuel Gauges are used to remotely monitor the fuel level of a diesel or propane fuel tank.
This document describes the Installation instructions for the power and relay harness on the SiteBoss 570
